Automatic configuration is super!

Zurko

Upgraded to 539 build & removed current cache devices & then used the new automatic configuration utility. The utility detected 1289mb of unmanaged (4gb Xp) & recommended me to utilize why 1023mb of Advanced Memory Cache – 4095mb of 250gb 2nd internal hard drive – 4095mb of 250gb 3rd internal hard drive – 3915mb of 4gb Flash Drive – 4095mb of 500gb external hard drive. I selected next & eboostr built the cache, on inspection the devices showed all cache drives were active except the System Memory which had an “X” next to it. I tried rebuilding cache several times & a fresh install of the new version, but I couldn’t get the System Memory to an active status. I then removed all devices & installed them one at a time (rebuilding cache with each new device) with the automatic recommendations stated above. On installing the system memory & selecting unmanaged & building cache the display named the device “Advanced Memory Cache”, before it had just named it as “System Memory” even though I selected to detect hidden in configuration. I continued adding the devices with all working ok until I installed the 4095mb of 500gb external hard drive (SEAGATE FreeAgent Desk 500GB) the display returned to “System Memory” & failed to reach active status. Having discovered this conflict I removed all devices & selected the automatic configuration utility, I then deselected the Seagate drive & the utility built the cache. After cache was built all devices became active (display returned to “Advanced Memory Cache”), my system has been running perfectly for a few hours now.

I will allow my system to fill the cache over the next few days & then test whether my system can utilize more than 1024mb of unmanaged (Build 538 failed beyond that point on my system previously), currently using 1023mb as recommended.

Freddy